Soudafix VE400-SF
Soudafix VE400-SF
SOUDAFIX VE400-SF is a two-component anchoring resin for the pressure-free securing of threaded rods (ETA: M8-M30), studs, reinforcement bars (ETA: Ø8-Ø32), threaded collars, profiles etc in various solid and hollow materials, such as cracked and uncracked concrete, solid brick, hollow brick, porous concrete, natural stone, plasterboard walls, etc…
Technical data sheet
Declaration of Performance
- Easy to use and to apply
- Fast cure
- Wide application area, even in wet drill holes, under water and at
temp. as low as –10°C
- Styrene free (low odour)
- Cartridge re-usable by simply exchanging static mixer
- Watertight and impermeable fixing
- High chemical resistance
- Fire Resistance class F120 (M8-M30)
- European Technical Approval Option 1 for application in cracked and
uncracked concrete
- Emission in indoor air class A+
- Fast cure
- Wide application area, even in wet drill holes, under water and at
temp. as low as –10°C
- Styrene free (low odour)
- Cartridge re-usable by simply exchanging static mixer
- Watertight and impermeable fixing
- High chemical resistance
- Fire Resistance class F120 (M8-M30)
- European Technical Approval Option 1 for application in cracked and
uncracked concrete
- Emission in indoor air class A+
Securing of heavy loads in solid and hollow building materials. Pressure free anchoring even close to edges. Can be used as repair mortar.
- Drill hole at recommended depth
- Clean drillhole with brush and air pump thouroughly
- Screw static mixer onto cartridge
- Dispense the first 10 cm of the product to waste (on piece of
cardboard) until an even colour (dark grey) is achieved, and the
product is well mixed
- Solid stone: fill the drill hole from bottom up.
- Hollow brick: insert sleeve and fill it bottom up, so that the resin
is pressed through the tiny holes of the sleeve
- Insert anchoring rod with twisting left-right motion
- Inspect the drill hole for adequate filling
- Observe hardening time. Don’t move the anchoring rod during curing
- Leave the excess of product to cure as well.
- Remove it mechanically with hammer and chisel once cured
- Install component, applying the right torque
- Clean drillhole with brush and air pump thouroughly
- Screw static mixer onto cartridge
- Dispense the first 10 cm of the product to waste (on piece of
cardboard) until an even colour (dark grey) is achieved, and the
product is well mixed
- Solid stone: fill the drill hole from bottom up.
- Hollow brick: insert sleeve and fill it bottom up, so that the resin
is pressed through the tiny holes of the sleeve
- Insert anchoring rod with twisting left-right motion
- Inspect the drill hole for adequate filling
- Observe hardening time. Don’t move the anchoring rod during curing
- Leave the excess of product to cure as well.
- Remove it mechanically with hammer and chisel once cured
- Install component, applying the right torque
Cartridge:
280 ml cartridge for standard skeleton gun
380 ml for use with special two-component gun.
280 ml cartridge for standard skeleton gun
380 ml for use with special two-component gun.
There is a risk of staining on porous substrates such as natural stone. On such substrates a preliminary compatibility test is recommended.